14R1200RT & 15R1200GS Spark Plug Wrench?

Anyone have the spec and/or a source for a spark plug wrench for the Wethead?

I ordered one from A&S by MotionPro and it didn't fit! Arggh!

Tom

I measured the plugs A&S sent me and they're 14mm. Does that seem right?

14mm deep well socket works fine. When you're putting in the new plug tighten by hand then back out about an 1/8th of and inch before final tightening, otherwise, the socket will get stuck in the taper at the bottom.

Thanks, Frank. Not surprised a fellow BMWROTB would come through! Mission accomplished, on the RT anyway; next the GS.

14mm deep well socket works fine. When you're putting in the new plug tighten by hand then back out about an 1/8th of and inch before final tightening, otherwise, the socket will get stuck in the taper at the bottom.

Just for clarity, you mean pull the socket back 1/8th inch, not back out the spark plug. The first time I read the post, it didn't make sense.

Look for a thin wall deep socket, it shouldn't get stuck

Jay

I found a thin wall, long socket at Harbor Freight... just FYI.