BMWSportTouring BMWST DB
Page 1 of 2 1 2 >
Topic Options
#727671 - 09/17/11 04:45 PM Parting out '97 R1100RT
cruisin Offline
Member

Registered: 11/10/01
Posts: 963
Loc: Fritch, Tx
I picked up a high mileage 1997 R1100RT last February to use as a parts bike for helping a friend rebuild his. Now that is all done, I am selling off the rest of the bike. below is a list of what is already gone. Shoot me a PM for inquires on availability of other parts and prices.

THESE PARTS ARE ALREAY SOLD OR USED ON THE OTHER BIKE:

BELLY PAN
MAIN RIGHT FAIRING PANEL
RIGHT FOOTPEG SIDE PANEL
HEADLIGHT
WINDSCREEN
TAIL-LIGHT
LEFT MIRROR
FRONT WHEEL
TRANSIMSSION
DRIVE SHAFT HOUSING
CLUTCH
RIGHT FRONT FOOTPEG
BOTH REAR FOOTPEGS
BOTH BLACK TRANGULAR SIDE PANELS
All of the parts to convert and RT-P to civilian (SOLD)

A couple things this bike has that is not normally asked about:

Remus SS muffler complete with cat. converter & O2 snsor; $150 + shipping
OEM radio w/antenna $75 + shipping

AND I have friend who has a right side fairing panel from an RT-P (black & white police colors) but it will need repainting, he's asking $150 + shipping for it.

Again the parts in the list above are sold. PM me for more info on this bike and any parts that I have left from the '98 (click on the link in my signature lines for more on it)

Top
#727904 - 09/18/11 09:03 PM Re: Parting out '97 R1100RT [Re: cruisin]
wmdonley Offline
Newer Member

Registered: 08/14/11
Posts: 23
Loc: SLO, California
*Moderator Edit*

Per the Classifieds Rules, for which there is a link at the top of the Classified Forum, you may not respond directly to ads. Please click on the seller's name and then use the e-mail or Private Message links provided.



Thank you.



Top
#730522 - 09/28/11 12:16 PM Re: Parting out '97 R1100RT [Re: cruisin]
cruisin Offline
Member

Registered: 11/10/01
Posts: 963
Loc: Fritch, Tx
From the '97 here is a short list of the more commonly sought after parts; some are still on the bike so it may take me a day or two to get them off, cleaned and ready to ship. Pictures of most are already in a file and I can send those if you provide an E-addy in your PM. I also have the BMW part numbers associated with each part in a spreadsheet so we can make sure you are getting the right part.

Prices are all plus UPS or USPS ground freight shipping.
Expedited shipping -- ie. overnight etc. will cost you what it costs me.

Alternator w/pulley, $100
Starter, $100
Gas tank filler cup, $25
Clutch lever, $15
Front brake lever $15
Valve covers $45 each
Heads, $225 each
Gas cap w/key, $35
Upper center fairing panel, $100
Fairing panel over gas tank, $50
Left main fairing panel, $150
Glove box door with key & lock, $45
Front fender (painted part), $50
Left shark fin, $20
Drive Shaft, $125
Left mirror body (new with primer), $35
Rightt mirror body (glacier green & scratched), $15
Dash Panel, $40 (has some rust on left speaker grill)
Left throttle body, $100
Right throttle body, $100
TPS, $35
Left fuel injector, $45
Right fuel injector, $45
Gas tank with all of the hardware inside, $225
Right lower fork tube, $100
Left upper fork tube $50
Right upper fork tube, $50

AND

I've asked the moderators to delete my ads for parting out the '98 in order to combine the parts left from it into this ad. Here is what's left with prices (plus shipping) Hint: Seeking multiple parts could save some money off prices listed. A lot of these parts are also still on the '97 at the same price, so there is a chance I have two of some of them.

Left shark fin, $20
Right shark fin bracket, $12
Fairing panel over gas tank, $50
Left and right lateral side panels $45 each. (the painted ones just below the seats :: these are not the black triangular shaped covers that seem to fly off of a lot of bikes)
Glove box door w/lock & key, $45
Black rear plastic part of front fender, $35
Rear (dove-tail)plastic fender $45
Gas tank with no hardware, $125
Rear brake pedal, $20
Rear brake master cylinder with reservoir, $50
Front brake calipers, $75 each
Rear brake caliper, $75
Instrument cluster wiring harness including all the bulbs, $35
Instrument panel light cluster turn sigs. fuel, oil, ABS, etc. (just the panel no wiring or bulbs), $70.
Tachometer, $60
Speedometer, $70
Trip odo reset cable, $10
Front ABS ring w/bolts, $30
Front and rear ABS sensors with spacer shims, $20 each
OEM horn, $10
Front plastic engine cover, $25
Shift lever (complete), $25
Center stand lift handle, $25
Left front foot peg (rubber is pretty worn), $15
Front turn signal sockets, $5 each
Tail-light unit with two additional bulbs on either side of brake light and two built-in flashing LED units attached to brake light wiring $100
Handle bars, $50 each
Starter, $100
Motronic unit, $225
Header pipe/s $90
Grips, $10 each
Right lower fork tube, $100
Left upper fork tube $50
Right upper fork tube, $50
Oil cooler, $75
Cooler inlet tube, $50
Cooler outlet tube, $40
Muffler/cat. $75
Air collector, $15
Left air duct, $25
Right air duct, $25
Left intake tube, $10
Right intake tube, $10
Shifter selector lever, $75
Rigid brake pipes (in and out of ABS unit 4 pieces), $40
Upper fork bridge, $150
lower fork bridge, $75
Front tele-lever, $150
Rear para-lever, $25
Temperature sensor, $10
Battery case, $25
Throttle cable cam box, $25
Fast idle cable, $15
Left throttle body, $100
Left fuel injector, $45
Right fuel injector, $45
Rear shock, $100 (35K miles)
Front main frame with VIN (by Tx law must be accompanied by title), $225
Primary rear sub frame, $175
Main wiring harness, $125
Fuse box & associated parts, $125
Ignition switch w/key.$75

Short block, $500 (main engine casing with pistons, cylinders, cam & chains, crank. etc. -- typical short block parts :: no heads; they are sold

Individual parts of short block:
Front engine case cover, $50
Cams (2), $200
Crank shaft, $75
Left cyl. $35
Right cyl. $35
Left piston, $35
Right piston, $35
Left connecting rod, $35
Right connecting rod, $35
Engine case, $150

Top
#736321 - 10/23/11 05:30 PM Re: Parting out '97 R1100RT [Re: cruisin]
cruisin Offline
Member

Registered: 11/10/01
Posts: 963
Loc: Fritch, Tx
now in the sold coumn:

Remus muffler & header
drive shaft housing
gear indicator switch
all of the foot pegs

Top
#745199 - 12/04/11 11:53 AM Re: Parting out '97 R1100RT [Re: cruisin]
cruisin Offline
Member

Registered: 11/10/01
Posts: 963
Loc: Fritch, Tx
side stand is now sold.

Top
#754792 - 01/21/12 04:01 PM Re: Parting out '97 R1100RT [Re: cruisin]
cruisin Offline
Member

Registered: 11/10/01
Posts: 963
Loc: Fritch, Tx
the left side main fairing panel and left lateral panel are now sold. (both from the glacier green '97)

Top
#759234 - 02/11/12 12:26 PM Re: Parting out '97 R1100RT [Re: cruisin]
cruisin Offline
Member

Registered: 11/10/01
Posts: 963
Loc: Fritch, Tx
Now in the sold column:

The rear fender from the '98

the tail-light unit with the additional sockets and LEDs

Top
#764530 - 03/08/12 05:56 PM Re: Parting out '97 R1100RT [Re: cruisin]
cruisin Offline
Member

Registered: 11/10/01
Posts: 963
Loc: Fritch, Tx
The following items from the '97 are now sold:

Dash panel
Right foot-peg panel
Both spark plug covers

Top
#772897 - 04/21/12 07:15 AM Re: Parting out '97 R1100RT [Re: cruisin]
cruisin Offline
Member

Registered: 11/10/01
Posts: 963
Loc: Fritch, Tx
The following items from the '97 are now sold:

left valve cover
heated grips
left switchgear

Top
#780934 - 06/01/12 05:15 AM Re: Parting out '97 R1100RT [Re: cruisin]
cruisin Offline
Member

Registered: 11/10/01
Posts: 963
Loc: Fritch, Tx
now in the sold column:

rear drop tail section of the '97
clutch cable
shifter selector lever PN / 23 31 1 340 372

Top
Page 1 of 2 1 2 >