Would I need to install a female quick connector on my R1200RT wiring OR I guess I could just cot and solder it?
Presently I just use bare connectors as my plastic has long disintegrated (even had to cut 2 inches off the brown wires and solder it to the connector on one plug as the copper wiring was disintegrating and only making occasional contact).
I like the idea of NOT having HOT and GROUND capable of touching during replacement - never been a problem so far - but just don't like the thought of any potential of a short) - so this thread gives me some (low cost) options (as $100 for the two connectors was a bit rich for me).
Does it matter if the TWO brown wires are on TOP or BOTTOM (I have them on the bottom) of the H7 Bulb? Where do these two brown wires go?