ESokoloff Posted December 3, 2017 Share Posted December 3, 2017 Some time ago while buttoning up my 03, I noticed that the pin on the triangle on the left side did not properly engage the grommet in the body panel. Previously I had replaced the pin with a 1/4-20 nut & bolt (& glue) as the plastic pin had sheared off (common issue). I had attributed the miss fit to an improper repair by yours truly Today I revisited the issue & discovered that the Center Stand lift handle's bracket must have bent slightly back/towards the rear of the bike & thus not allowing the triangle to be in the proper position thus causing the pin to not properly engage the body panel grommet. A few strategic smacks on the extended handle with my palm corrected this issue. Hope this helps someone else but use with caution & @ your own risk. Link to comment
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now