Retired At LAst Posted December 29, 2017 Share Posted December 29, 2017 I pryed up the old oil cap holder with o ring No problem How do I insert the new one. It just wont pop in no matter how hard I push Whats the trick? Link to comment
AnotherLee Posted December 29, 2017 Share Posted December 29, 2017 (edited) Ret - Have you tried Tri750's method? “...a pocket screwdriver and patience will get the plastic base out fine. Clean the residual oil, new o ring and press down with one thumb while you slowly tuck the oring in with the same screwdriver around the perimeter of the plastic base. Just small bites at a time. It will work in.” Pretty cold up there? Edited December 29, 2017 by TheOtherLee Link to comment
SAS Posted December 29, 2017 Share Posted December 29, 2017 I used a socket the same size as the insert, and tapped it in with a mallet. What size you say?, well I don't remember off hand. I also used some EZ Turn to lube up the "O" ring to ease the installation. Link to comment
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now