I just got all the new rotors and pads installed, I pulled the brake lever and it went all the way down to the hand grip!!
I pumped it up but with steady pressure just kept moving down to the grip.
I then discovered that the wheel was jammed tight, I could barely move it then suddenly the LH lower brake hose swelled and burst!! confused
Now I am in a fix, I assume I'll now have to replace the lower 2 hoses (minimum) and bleed the brakes.
But what caused the pressure build up and the wheel to lock up?
If I repair it what's to stop it from happening again? Where did I go wrong?
Please Help! dontknow

I just had a horrible thought, it's ABS, I probably should have had the bike running, the manual never mentioned anything. Could there be any damage to the, I assume, power assistance??