AZKomet Posted December 26, 2009 Share Posted December 26, 2009 I know anything is possible....but my V1 display just stopped working. Replaced: Power supply unit, power cord and all I can say is hmmmmmm...???? Anyone have an idea? The V1 works but no remote display. Link to comment
Bill_Walker Posted December 26, 2009 Share Posted December 26, 2009 Check the cables. Also make sure you've got them in the right jacks in the power supply unit. Link to comment
David Posted December 26, 2009 Share Posted December 26, 2009 That particular piece is really sensitive to moisture. Could some have gotten in it? Link to comment
AdventurePoser Posted December 27, 2009 Share Posted December 27, 2009 I second David's comment...Moisture wreaks havoc on that part. Depsite my best efforts, once my rmote got wet that was it...had to wait a few days, it dried out, and all was good again! Good luck, Steve Link to comment
Smoky Posted December 27, 2009 Share Posted December 27, 2009 Mine would quite for while after getting wet. it always went back to working when given a chance to dry. Link to comment
AZKomet Posted December 27, 2009 Author Share Posted December 27, 2009 I have not gotten it wet to my knowledge as it is well protected in the w/s area of my bike. It just stopped working.......not sure why but I have spent time diagnosing it with new wires, a new power unit I had as a spare and even new fuses to all my power cables. So I give...... Thanks for your help. Link to comment
BerryG Posted December 31, 2009 Share Posted December 31, 2009 Did you get new wires from Valentine? I think the remote uses different wiring than a regular phone line. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.