Lee from Texas Posted June 24, 2012 Share Posted June 24, 2012 Trying to get some assistance in the installation of a BMW Motorrad Communication System in a new Schuberth C3 helmet. After find some instructions on the Internet after finding nothing in the BMW package, I've removed the helmet liners but found that the cavity where you're supposed to insert the battery package is a bit too small, causing the helmet's inner shock absorbing material to bulge inward. Is this normal?? Have to say I'm a bit irritated since the dealer won’t install this, even though I just dropped over a grand on the comm system and the C3 helmet. Any assistance is greatly appreciated. Link to comment
bgf50 Posted June 25, 2012 Share Posted June 25, 2012 http://prodmedia.bmwuniversity.com/MOTO/Schuberth%20-%20Communications%20System%20set%20up.wmv Here is the video for installation. I've done it twice. It is a giant pain but works really well. Battery and circuit board are both a tight fit. Bill 2012 RT, 09 KLR Link to comment
Lee from Texas Posted July 7, 2012 Author Share Posted July 7, 2012 After sending out several postings and emails for assistance, I was contacted by a tech rep at Schuberth who offered to install everything if I shipped it to him. It was worth it to get it done right, and to know I didn't violate the integrity (and warranty) of the helmet! Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.