Lone_RT_rider Posted February 12, 2016 Share Posted February 12, 2016 I have to re-install my autocomm microphone boom into the new Shoei X12 helmet. I had previously installed this into my X11 and didn't really have an issue pulling the liner out and getting it to go where I needed it to. But..... this X12 looks to be configured just a bit differently. Would anyone know of anything I should be aware of before I take a butter knife and try to start to remove the cheek pads? I was hoping to get this done this weekend. Shawn Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.